27-03-2010, 11:12 AM
Can someone please help me,
I have recently bought the Beninca R1.6E . I also bought 2 FTC’s and an antenna with 2 remote controls. Firstly, is all this adequate for a basic operation of a sliding gate. Secondly I am having trouble with the wiring of the FTC’s. 1 of the FTC’s has 2 connections(+-) and the other has 5 connections (+- COM NO NC) ,could you tell me which number on the pcb these go to please, I have looked at the drawing but it doesn’t state clearly which number they go to. The antenna is shown going to 21 & 22 on the pcb . How are these connected, is there a special connector to attach to the outer wire of the aerial cable going to no.22 is it just twisted until it goes into the connector, I have attached the pcb diagram,thankyou, Andylad
I have recently bought the Beninca R1.6E . I also bought 2 FTC’s and an antenna with 2 remote controls. Firstly, is all this adequate for a basic operation of a sliding gate. Secondly I am having trouble with the wiring of the FTC’s. 1 of the FTC’s has 2 connections(+-) and the other has 5 connections (+- COM NO NC) ,could you tell me which number on the pcb these go to please, I have looked at the drawing but it doesn’t state clearly which number they go to. The antenna is shown going to 21 & 22 on the pcb . How are these connected, is there a special connector to attach to the outer wire of the aerial cable going to no.22 is it just twisted until it goes into the connector, I have attached the pcb diagram,thankyou, Andylad
