10-11-2008, 01:49 PM
This could be caused by colder weather and the motor needing more force in colder conditions.
First thing to try is to turn up the force on the circuit board and see if this cures the problems.
Also double check you geometry of the brackets to make sure the brackets are installed correctly if not this will cause the arm to wear and eventually fail.
Geometry measurements for the LYN300 can be found at this link :
http://www.easygates.co.uk/24v-geo-chart.asp
First thing to try is to turn up the force on the circuit board and see if this cures the problems.
Also double check you geometry of the brackets to make sure the brackets are installed correctly if not this will cause the arm to wear and eventually fail.
Geometry measurements for the LYN300 can be found at this link :
http://www.easygates.co.uk/24v-geo-chart.asp