BFT Deimos gate won't close

[Arthur_k99]

Hi Arthur,

The photo warning normally only comes up where there is a fault with the photocells, I would look at changing them, if your certain the wiring to the photocells are ok.

Do you know how to test wiring for a open/short circuit?

Do you mean the code SWC code came up, rather than what you mentioned below SUC? SWC would be the correct code. If this is coming up when you have linked out the photocells, then change the photocells mate as they are causing the problem.

Let me know how you get on.

http://securitysystems.createaforum.com/index.php

Hi PAJ,

Thanks for your reply. Could you please advise me on the best way to test wiring for a open/short circuit?

I've used a wire to link between connection (21 Common - 24 Photobeam).
When I linked 21 and 24 (photo beam), the display code which shows was "Suc" code, definitely not SWC code. Does this "Suc" code means there is a fault with the photocells?

I've open the covers of the two photocells and checked that there weren't any loose connections with the circuit boards.
The circuit board of the photocell which shown that it's "Centurion" brand and "Input voltage 12v - 30v AC or DC".

My gate can be open without any problem. But when I tried to close it, the gate reached at about halfway point, then it suddenly stopped, as if there was something blocked the photocells. There was an error code "Anp" which was showed and then following with an error code "Phot" that was showed on the board.

Any suggestions on how to fix the error codes "Anp" and "Phot" and close the gate fully?

Thanks,
Arthur